I'm on Twitter

Roosty6 @B110

Friday, June 28, 2013

Trike Driving and Tree Cutting


A small job gets bigger sometimes. I'd found this huge poplar tree that had leaned over almost horizontal in the field the other day while I was spraying the crop for weeds. A victim of last week's terrible winds. I decided to get it cleaned up while it was fresh in my mind or else I would forget about it till harvest time and have to drive around it with the swather. Headed out through the wet field with trike and chain saw and got a good start but came to a standstill. Got the saw jammed in the cut and there was no way I could pull it out. No tools so I headed home for a hammer and wood chisel. Of the various wood chisels I own, I could not find one. Settled for a dull old steel chisel and nail hammer which was a poor choice. I ended up making another trip home for a hand saw which turned out to be a better option. I got plenty of exercise using a hand saw on green wood on a hot summer day to release the chain saw bar. With the heat and the clouds of fuzz flying off that tree I felt like I was being tarred and feathered by the time I was done.

Between the crop I flattened out with the trike tires and then my size 13 work boots I probably lost more crop than if I had just left the tree in the field and drove around it at harvest time.

2 comments:

  1. I always carry at least two chainsaws when the target is a full tree. The large one to get stuck in a bind, and a small one to get it unstuck and to cut the smaller branches because it's lighter.

    ReplyDelete